You should hear a beep. How to Reset to Factory Reset a Camera Using the Web UI. An LED will light the button.It resets the Amcrest camera back to its original factory defaults. In our case, you would like to proceed with pressing this button for … This will ultimately restore the device to its factory settings and will reset ALL of the camera's settings. If you’ve got planned to perform a tough reset of your Amcrest camera, then locate the external factory push button at the backside of your Amcrest camera. Be careful with this button in standard scenarios once you don’t want to reset your camera. To factory reset the Amcrest NVR, hold the reset button down and unplug the NVR from power. Press and hold the factory reset button for approximately 20 seconds, or until the green light changes to red. Note: Using the Restore to Default Settings button directly from the web user interface of your device will not reset the admin password for your device.To reset the password, a physical, hard factory reset will … Once the light turns red, the process will begin. Continue holding the reset button and allow the device to initialize for 20 – 30 seconds and then … Once the power cord is removed from the unit, continue holding the factory reset switch for 10 seconds, then still continuing to hold the reset switch, plug the power cord (supply) back into the unit.